I just picked up this 214 SMA from Craigslist the other day and have been repairing it.. I have a service manual on the way. So far ive replaced the air filter, oil, carburetor, spark plug, cleaned gas tank, and a new blade.
When i restarted the mower i could here a grinding noise.. Sounded like a bearing to me so i removed the Roto stop and found the bad bearing. I just ordered one today.
Anyway, while im in there, is there anything else i should replace? The clutch plate is worn to about 2.8MM thickness.. It did engage the blade but i read somewhere that is should be at least 4.6mm? Should i replace it while im in there? If it needs to be replaced, where would you recommend buying it? Ive seen some on eBay and i would probably go that route if i need one.. Thanks!
When i restarted the mower i could here a grinding noise.. Sounded like a bearing to me so i removed the Roto stop and found the bad bearing. I just ordered one today.
Anyway, while im in there, is there anything else i should replace? The clutch plate is worn to about 2.8MM thickness.. It did engage the blade but i read somewhere that is should be at least 4.6mm? Should i replace it while im in there? If it needs to be replaced, where would you recommend buying it? Ive seen some on eBay and i would probably go that route if i need one.. Thanks!