Crank case gasket was leaking oil. Removed engine replaced gasket and PTO side seal. Reassembled and installed engine. Upon restarting the engine there was no hesitation it fired right up, but it will not idle it just stays at constant high rpm. Followed Briggs and Stratton instructions onSetting the governor. After setting governor issue was still present. Repeated governor setting and throttle settings three times just to make sure I was doing it properly. Assuming I did the procedure properly I am stumped and not sure where to go?
Craftsman lawn mower(riding) 917.288320
Briggs and Stratton 24hp v-twin intek 445677-0725-e1
Craftsman lawn mower(riding) 917.288320
Briggs and Stratton 24hp v-twin intek 445677-0725-e1